Yamaha DSP-E800 - Page 20

DSP-E800
DSP-E800
17
1 2. DSP - E
The version and the check sum of the microcomputer software are displayed.
A01: Microcomputer software version
824E: Microcomputer software check sum
The model type and the destination are displayed.
DSP-E: Model type
DSP-E= DSP-E800
EXIT
No.11 EEPROM WRITING FUNCTION
The check sum value confirmation of EEPROM and data writing
No.12 UNIT INFORMATION/EXIT
The version of the microcomputer and the check sum, the model type and the destination are displayed.
By the sub-menu operation, the set exits the self-diagnosis mode and returns to the normal operating mode.
12. A01 824E
M:XXXX: The check sum value is displayed when the microcomputer has ROM
modification data.
0000 is displayed when there is no data.
E:XXXX: The check sum value is displayed when the EEPROM is installed on and
it has the ROM data .
000 is displayed when EEPROM is not installed on or data is unusual.
If you want to write ROM modification data of the microcomputer into the
EEPROM, change to the next sub-menu.
M:XXXX E: XXXX
Version Check sum
Model type