– 3 –
AE00088
CONNECTION NOTES
9 Avoid connecting the generator to commercial power out-
let.
9 Avoid connecting the generator in parallel with any other
generator.
1 Correct
2 Incorrect
AE00091
CONNECTION
w
Before the generator can be connected to a build-
ing’s electrical system, a licensed electrician must
install an isolation (transfer) switch in the build-
ing’s main fuse box. The switch is the connection
point for generator power and allows selection of
generator or main line power to the building. This
will prevent the generator from charging the main
power line (backfeeding) when the main power
supply has failed or has been turned off for line
repair. Backfeeding can electrocute or injure line
maintenance personnel. Also, generator and build-
ing electrical system damage can occur when nor-
mal operating power returns if unit is used without
an isolation switch.
7CB-F8199-11_a 07.12.22 16:30 Page 3
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
