– 22 –
AE00839
Connection
Alternating Current (AC)
w
Be sure any electric devices are turned off before
plugging it in.
cC
9 Be sure all electric devices including the lines
and plug connections are in good condition
before connection to the generator.
9 Be sure the total load is within generator rated
output.
9 Be sure the receptacle load current is within
receptacle rated current.
NOTE:
Make sure to ground (earth) the generator.
When the electric device is earthed, always the gener-
ator must be earthed.
1. Start the engine.
2. Plug in to the AC receptacle.
3. Make sure the voltage meter indicates the rated
voltage.
If the voltage meter does not indicate the rated
voltage (i.e., when using an extension cord, etc),
use the voltage adjuster to adjust the output volt-
age to the rated voltage.
q
779-039a
A
å Voltage meter
NOTE:
Turn the adjuster clockwise or conterclockwise to
increase or decrease output voltage.
1 Voltage adjuster
7CB-F8199-11_a 07.12.22 16:30 Page 22
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
