Operation
71
3. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
4. Place the throttle grip in the “”
(start) position. After the engine starts, re-
turn the throttle to the fully closed posi-
tion.
5. Turn the main switch to “” (start),
and hold it for a maximum of 5 seconds.
6. Immediately after the engine starts, re-
lease the main switch and allow it to re-
turn to “” (on). NOTICE: Never turn
the main switch to “” (start)
while the engine is running. Do not
keep the starter motor turning for
more than 5 seconds. If the starter mo-
tor is turned continuously for more
than 5 seconds, the battery will be
quickly discharged, thus making it im-
possible to start the engine. The start-
er can also be damaged. If the engine
will not start after 5 seconds of crank-
ing, return the main switch to “”
(on), wait 10 seconds, then crank the
engine again.
[ECM00192]
IP:
●
When the engine is cold, it needs to be
warmed up. For further information, see
page 74.
●
If the engine is warm and fails to start, open
the throttle slightly and try to start the en-
gine again. If the engine still fails to start,
see page 105.
EMU42430
Electric start and remote control models
WARNING
EWM01840
●
Failure to attached engine shut-off cord
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-off
cord to a secure place on your clothing,
or your arm or leg while operating. Do
not attach the cord to clothing that could
tear loose. Do not route the cord where
it could become entangled, preventing it
from functioning.
●
Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power, the
U63P1DE0.book Page 71 Tuesday, March 29, 2011 7:15 PM
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
