Yamaha F150D1 - Procedure for Tilting down; Shallow Water; Cruising in Shallow Water

Operation
70
EMU42702
Procedure for tilting down
1. Push the power trim and tilt switch “ ”
(up) until the outboard motor is support-
ed by the tilt rod and the tilt support lever
becomes free.
2. Release the tilt support lever.
3. Push the power trim and tilt switch “ ”
(down) to lower the outboard motor to
the desired position.
EMU28063
Shallow water
EMU40702
Cruising in shallow water
The outboard motor can be tilted up partially
to allow operation in shallow water.
NOTICE
ECM02361
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
1. Power trim and tilt switch
ZMU07851
DN
1
1. Power trim and tilt switch
1. Power trim and tilt switch
ZMU07853
DN
1
1
DN
ZMU07771
U63P3GE0.book Page 70 Monday, December 15, 2014 2:02 PM
©2019 Yamaha Motor Corporation, U.S.A.