Yamaha F150G - Stopping Engine; Procedure for Stopping Engine

Operation
56
engine speed is increased from the fully
closed position during trolling speed setting
mode. When the throttle is returned to the ful-
ly closed position, the display will show the
trolling speed again. When the engine is
turned off or when the engine speed exceeds
3000 r/min, trolling speed setting mode will
be released.
For details, see the attached operation man-
ual.
TIP:
 Trolling is affected by currents and other
operating conditions and may differ from
the actual engine speed.
 When warming up a cold engine, the troll-
ing speed cannot be decreased below the
specified engine idle speed.
EMU27822
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU41913
Procedure for stopping engine
1. The engine can be turned off either by
pressing the Start/Stop button or by
turning the main switch to the “ ” (off)
position. After the engine has been
turned off using the Start/Stop button,
turn the main switch to the “ ” (off) po-
sition.
ZMU06309
Troll stop
SET
MENU
CANCEL
ZMU07256
ON
OFF
ZMU07171
ZMU07148
U6DV75E0.book Page 56 Tuesday, February 21, 2017 8:33 AM