Maintenance
78
EMU29116
Inspecting wiring and connectors
Inspect that each connector is engaged se-
curely.
Inspect that each ground lead is properly
secured.
EMU41671
Inspecting propeller
EWM02681
You could be seriously injured if the en-
gine accidentally starts when you are near
the propeller. Before inspecting, remov-
ing, or installing the propeller, move the
control lever to the neutral position, turn
the main switch to the “ ” (off) position,
remove the key, and remove the clip from
the engine shut-off switch. Turn off the
battery cut-off switch if your boat has one.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
nut. Place a block of wood between the anti-
cavitation plate and the propeller to prevent
the propeller from turning.
Checkpoints
Check each of the propeller blades for ero-
sion from cavitation or ventilation, and oth-
er damage.
Check the propeller shaft for damage.
Check the splines for wear and damage.
Check for fish line tangled around the pro-
peller shaft.
U6DV75E0.book Page 78 Tuesday, February 21, 2017 8:33 AM
To Next Page
