Yamaha F150G - Inspecting and Replacing Anode(S); Checking Battery (for Electric Start Models)

Maintenance
82
TIP:
Apply a light coat of gear oil to the oil level
plug thread and gasket before installation.
7. Put a new gasket on the gear oil drain
screw. Insert and tighten the gear oil
drain screw to the specified torque.
TIP:
Apply a light coat of gear oil to the gear oil
drain screw thread and gasket before instal-
lation.
EMU29318
Inspecting and replacing anode(s)
Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
NOTICE
ECM00721
Do not paint anodes, as this would render
them ineffective.
TIP:
Inspect ground leads attached to external an-
odes on equipped models. Consult a
Yamaha dealer for inspection and replace-
ment of internal anodes attached to the pow-
er unit.
EMU29324
Checking battery (for electric start
models)
WARNI NG
EWM01903
Battery electrolyte is poisonous and caus-
tic, and batteries generate explosive hy-
drogen gas. When working near the
battery:
 Wear protective eye gear and rubber
gloves.
 Do not smoke or bring any other source
of ignition near the battery.
Tightening torque:
7 N·m (0.71 kgf·m, 5.2 lb·ft)
Tightening torque:
7 N·m (0.71 kgf·m, 5.2 lb·ft)
1. Anode
1
1
ZMU07784
U6DV75E0.book Page 82 Tuesday, February 21, 2017 8:33 AM