4-14
E
EMU01742
CHANGING ENGINE OIL
WARNING
@
●
Avoid draining the engine oil immedi-
ately after stopping the engine. The oil
is hot and should be handled with care
to avoid burns.
●
Be sure the outboard is securely fas-
tened to the transom or a stable stand.
@
CAUTION:
@
●
Change the engine oil after the first 10
hours of operation, and every 100
hours or at 6-month intervals thereaf-
ter. Otherwise, the engine will wear
quickly.
●
Do not overfill the oil, and be sure the
engine is in an upright position (not
tilted) when checking and changing
the engine oil.
●
If the oil level is above the upper level
mark, drain until the level meets the
specified capacity. Overfilling the oil
may cause leakage or damage.
@
NOTE:
@
Change the engine oil when the oil is still
warm.
@
1) Put the outboard motor in an upright
position (not tilted).
2) Prepare a suitable container which can
hold a larger amount than the engine oil
capacity. Loosen and remove the drain
bolt
1
holding the container under the
drain hole. Let the oil drain completely.
Wipe up any spilled oil immediately.
3) Put a new gasket on the drain bolt.
Apply a light coat of oil to the gasket and
reinstall the drain bolt.
Tightening torque:
Refer to “SPECIFICATIONS”, page 4-1.
To Next Page
Loading...
