Yamaha F70A - Engine Oil; Engine; Flushing Device

Operation
51
EMU37052
Engine oil
1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01790]
2. Remove oil dipstick and wipe it clean.
3. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
4. Check the oil level using the dipstick to
be sure the level falls between the upper
level mark and lower level mark. Consult
your Yamaha dealer if the oil level is out
of specified level or if it appears milky or
dirty.
EMU27153
Engine
● Check the engine and engine mounting.
● Look for loose or damaged fasteners.
● Check the propeller for damage.
● Check for engine oil leaks.
EMU36492
Flushing device
Check that the flushing device’s garden hose
connector is securely screwed on to the fit-
ting on the bottom cowling. NOTICE: If the
garden hose connector is not properly
connected, cooling water can leak out
and the engine can overheat during oper-
ation.
[ECM01801]
1. Oil dipstick
1. Lower level mark
1
ZMU05089
132
ZMU05091
2. Oil dipstick
3. Upper level mark
1. Fitting
2. Flushing device
2
1
ZMU06056
6C1-9-26-1E0.book 51 ページ ２０１０年２月１０日 水曜日 午後１時５３分