What to do if Yamaha FT8DEP Outboard Motor trim gauge always shows fully tilted up position?
If the trim gauge always shows a fully tilted-up position, the trim sender signal is not being received. Connect the pink lead connectors to each other.
Why Yamaha Outboard Motor boat speed and/or coolant pressure gauge does not show?
If the boat speed and/or coolant pressure gauge does not show, it is likely that the optional sensor has not been installed. Install the optional sensor.
General| Engine Type | 4-stroke, SOHC |
|---|---|
| Power Output | 8hp |
| Starting System | Manual |
| Gear Ratio | 2.08:1 |
| Propeller Shaft Horsepower | 8hp |
| Fuel Induction System | Carburetor |
| Ignition System | CDI |
| Lubrication | Wet sump |
| Exhaust | Through propeller hub |
| Cooling | Water-cooled |
| Alternator Output | 6A |
| Fuel Tank Capacity | 12 litres |
| Full Throttle RPM Range | 5000-6000 rpm |
| Fuel Type | Gasoline |
| Shaft Length | 15 in |
To Next Page
