61
English
REMOTE CONTROL FEATURES
ADVANCED
OPERATION
You can control other components by setting the
appropriate manufacturer codes. Codes can be set up for
each input area. For a complete list of available
manufacturer codes, refer to “LIST OF
MANUFACTURER CODES” at the end of this manual.
The following table shows the factory preset component
(Library: component category) and the manufacturer code
for each area.
You may not be able to operate your YAMAHA component even
if a YAMAHA manufacturer code is initially set as listed above.
In this case, try to set other YAMAHA manufacturer code(s).
1 Press an input selector button or to
select the component you want to set up.
2 Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
3 Press the numeric buttons to enter the four
digit manufacturer’s code for the component
to be used.
Refer to “LIST OF MANUFACTURER CODES” at
the end of this manual.
The TRANSMIT indicator on the remote control
flashes twice.
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you wait for more than 30 seconds during step 3, the setup
process is canceled. If this happens, start over from step 2.
Setting manufacturer codes
Input area
Component
category
(Library)
Manufacturer Code
CD CD YAMAHA 0005
MD/CD-R MD YAMAHA 0024
TUNER TUNER YAMAHA 0003
DVD DVD YAMAHA 0098
DTV/CBL – – –
V-AUX – – –
VCR 1 – – –
DVR/VCR2
–––
–––
Note
Notes
CD
MD/CD-R
TUNER
V-AUX
DVD
AMP
VCR 1 DVR/VCR2
DTV/CBL
MULTI CH IN
SLEEP
TRANSMIT
CODE SET
STRAIGHT
ROCKJAZZHALLSTEREO
4321
8
10
7
09
65
ENTER
MOVIETV THTRMUSIC ENTERTAIN
EX/ESNIGHTq/DTS
EFFECT
00_HTR-5760_U_EN.book Page 61 Tuesday, February 17, 2004 10:47 AM
To Next Page
Loading...
Need help?
General
