To Next PageTo Next PageWhy is there no sound from the surround speakers of my Yamaha Receiver?
If there is no sound from the surround speakers on your Yamaha Receiver, the output level of the surround speakers may be set to minimum (raise the output level of the surround speakers). Additionally, if a monaural source is being played with program 9, select another sound field program.
Why is there no sound from the subwoofer of my Yamaha HTR-5830?
If there is no sound from the subwoofer connected to your Yamaha Receiver, check the “SOUND 1D BASS” setting on the set menu. If it is set to FRNT when a Dolby Digital or DTS signal is being played, select SWFR or BOTH. If it is set to SWFR or FRNT when a 2-channel source is being played, select BOTH.
What causes continuous crackling and hissing noises in Yamaha HTR-5830?
Continuous crackling and hissing noises in your Yamaha Receiver can result from lightning, fluorescent lamps, motors, thermostats, and other electrical equipment. Using an outdoor antenna and a ground wire may help, but it is difficult to eliminate all noise.
What causes buzzing and whining noises in Yamaha HTR-5830?
Buzzing and whining noises (especially in the evening) in your Yamaha Receiver can be caused by a TV set being used nearby. Move this unit away from the TV.
General| Audio Channels | 5.1 |
|---|---|
| Frequency Response | 10 Hz - 100 kHz |
| Component Video Inputs | 2 |
| Composite Video Inputs | 4 |
| Signal-To-Noise Ratio | 100 dB |
| Input Sensitivity | 200 mV |
| Built-in Decoders | Dolby Digital, DTS |
| Surround Sound Effects | Yes |
| Tuner Bands | AM/FM |
| Preset Station Qty | 40 |
| Surround Sound | Yes |
| S-Video Inputs/Outputs | 2 inputs / 1 output |
| Digital Audio Inputs | 2 (optical, coaxial) |
| Total Harmonic Distortion | 0.06 % |
| Input Impedance | 47 kΩ |
| Audio D/A Converter | 24-bit/192 kHz |
| Tuning Range | FM: 87.5 - 108 MHz, AM: 530 - 1710 kHz |
| Width | 17.1 in |
| Power Output | 100 W |
| Connector Type | RCA |
