Yamaha LF130 - Inspecting and Replacing Anode(S)

Maintenance
96
TIP:
For disposal of used oil, consult your Yamaha
dealer.
(5) Put the outboard motor in a vertical posi-
tion. Using a flexible or pressurized filling
device, inject the gear oil into the gear oil
drain screw hole.
(6) Put a new gasket on the oil level plug.
When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug to the specified torque.
TIP:
Apply a light coat of gear oil to the oil level
plug thread and gasket before installation.
(7) Put a new gasket on the gear oil drain
screw. Insert and tighten the gear oil
drain screw to the specified torque.
TIP:
Apply a light coat of gear oil to the gear oil
drain screw thread and gasket before instal-
lation.
EMU29318
Inspecting and replacing anode(s)
Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
ECM00721
Do not paint anodes, as this would render
them ineffective.
2. Oil level plug
Recommended gear oil:
Yamalube Marine Gearcase Lube HD
or Hypoid gear oil
Recommended gear oil grade:
SAE 80W API GL-5 / SAE 90 API GL-
5 (LF130A)
SAE 90 API GL-4 / SAE 80W API GL-
5 / SAE 90 API GL-5 (F115B, F130A,
LF115B)
Gear oil quantity:
0.715 L (0.756 US qt, 0.629 Imp.qt)
(LF115B, LF130A)
0.760 L (0.803 US qt, 0.669 Imp.qt)
(F115B, F130A)
ZMU08122
Tightening torque:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
Tightening torque:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
U6EK38E0.book Page 96 Wednesday, December 1, 2021 10:35 AM