Yamaha LF130 - Stopping Engine; Procedure

Operation
68
 If the trolling speed has been adjusted, the
engine returns to the normal trolling speed
when the engine is stopped and restarted
or when the engine speed exceeds ap-
proximately 3000 r/min.
EMU27823
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU2784A
Procedure
(1) Push and hold the engine stop button or
turn the main switch to “ ” (off).
(2) After stopping the engine, disconnect
the fuel line if there is a fuel joint on the
outboard motor.
(3) Tighten the air vent screw on the fuel
tank cap (if equipped).
(4) Remove the key if the boat will be left un-
attended.
ON
OFF
ZMU01779
ZMU06932
ON
OFF
OFFOFF
ON ON
ZMU05833
U6EK38E0.book Page 68 Wednesday, December 1, 2021 10:35 AM