Yamaha LF200 - Drive Unit and Fluid Requirements

Specifications and requirements
14
Drive unit:
Gear shift positions:
Forward-neutral-reverse
Gear ratio:
2.00(30/15)
Trim and tilt system:
Power trim and tilt
Propeller mark:
F200A M/T
F225A M/T
F250A M/T
LF200A ML/TL
LF225A ML/TL
LF250A ML/TL
Fuel and oil:
Recommended fuel:
F200A Regular unleaded gasoline
F225A Regular unleaded gasoline
F250A Premium unleaded gasoline
LF200A Regular unleaded gasoline
LF225A Regular unleaded gasoline
LF250A Premium unleaded gasoline
Min. pump octane number:
F200A 86
F225A 86
F250A 89
LF200A 86
LF225A 86
LF250A 89
Recommended engine oil:
YAMALUBE 4-M FC-W or 4-stroke
outboard motor oil
Recommended engine oil grade 1:
SAE 10W-30/10W-40/5W-30
API SE/SF/SG/SH/SJ/SL
Engine oil quantity (without oil filter
replacement):
4.5 L (4.76 US qt, 3.96 Imp.qt)
Engine oil quantity (with oil filter
replacement):
4.7 L (4.97 US qt, 4.14 Imp.qt)
Lubrication system:
Wet sump
Recommended gear oil:
Hypoid gear oil
Recommended gear oil grade:
SAE 90 API GL-4
Gear oil quantity:
F200A 1.150 L (1.216 US qt,
1.012 Imp.qt)
F225A 1.150 L (1.216 US qt,
1.012 Imp.qt)
F250A 1.150 L (1.216 US qt,
1.012 Imp.qt)
LF200A 1.000 L (1.057 US qt,
0.880 Imp.qt)
LF225A 1.000 L (1.057 US qt,
0.880 Imp.qt)
LF250A 1.000 L (1.057 US qt,
0.880 Imp.qt)
Tightening torque for engine:
Spark plug:
25 Nm (2.55 kgf-m, 18.4 ft-lb)
Propeller nut:
55 Nm (5.61 kgf-m, 40.6 ft-lb)
Engine oil drain bolt:
28 Nm (2.86 kgf-m, 20.7 ft-lb)
Engine oil filter:
18 Nm (1.84 kgf-m, 13.3 ft-lb)
EMU33554
Installation requirements
EMU33564
Boat horsepower rating
WARNING
EWM01560
Overpowering a boat can cause severe in-
stability.
Before installing the outboard motor(s), con-
firm that the total horsepower of your out-
board motor(s) does not exceed the boats
maximum horsepower rating. See the boat’s
capacity plate or contact the manufacturer.
U6AL32E0.book Page 14 Monday, April 9, 2012 11:55 AM
©2019 Yamaha Motor Corporation, U.S.A.