Yamaha LF200 - Operation; Initial Operation and Break-In

Operation
49
EMU36483
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU37053
Engine oil
1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01790]
2. Remove oil dipstick and wipe it clean.
3. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
4. Check the oil level using the dipstick to be
sure the level falls between the upper lev-
el mark and lower level mark. Consult
your Yamaha dealer if the oil level is out
of specified level or if it appears milky or
dirty.
EMU27153
Engine
●
Check the engine and engine mounting.
● Look for loose or damaged fasteners.
●
Check the propeller for damage.
●
Check for engine oil leaks.
EMU36493
Flushing device
Check that the flushing device’s garden hose
connector is securely screwed on to the fitting
on the bottom cowling. NOTICE: If the gar-
den hose connector is not properly con-
1. Cord
2. Clip
3. Engine shut-off switch
1. Cord
2. Clip
3. Engine shut-off switch
ZMU04565
1
2
3
ON
STARTOFF
ON
STARTOFF
1
2
3
ZMU05818
1. Oil dipstick
1. Oil dipstick
2. Lower level mark
3. Upper level mark
ZMU05972
1
1
3
2
ZMU07057
U6AL32E0.book Page 49 Monday, April 9, 2012 11:55 AM
©2019 Yamaha Motor Corporation, U.S.A.