Operation
50
nected, cooling water can leak out and the
engine can overheat during operation.
[ECM01801]
EMU36941
Install cowling
1. Be sure that all cowling lock levers are re-
leased.
2. Be sure that the rubber seal is seated all
the way around the engine.
3. Place the cowling on top of the seal.
4. Check to be sure it fits properly in the rub-
ber seal.
5. Move the levers to lock the cowling as
shown. NOTICE: If the top cowling is
not installed correctly, water spray un-
der the top cowling can damage the
engine, or the top cowling can blow off
at high speeds.
[ECM01991]
After installing, check the fitting of the top
cowling by pushing it with both hands. If the
top cowling is loose, have it repaired by your
Yamaha dealer.
1. Fitting
2. Flushing device
U6AL32E0.book Page 50 Monday, April 9, 2012 11:55 AM
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
