EasyManua.ls Logo

Yamaha LF200 - Inspecting Wiring and Connectors; Checking Propeller

Yamaha LF200
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance
76
11. Start the engine and make sure that the
low oil pressure-alert indicator remains
off. Also, make sure that there are no oil
leaks. NOT ICE: If the low oil pressure-
alert indicator comes on or if there are
oil leaks, stop the engine and find the
cause. Continued operation with a
problem could cause severe engine
damage. Consult your Yamaha dealer
if the problem cannot be located and
corrected.
[ECM01622]
12. Dispose of used oil according to local
regulations.
TIP:
For more information on the disposal of
used oil, consult your Yamaha dealer.
Change the oil more often when operating
the engine under adverse conditions such
as extended trolling.
EMU29114
Inspecting wiring and connectors
Inspect that each connector is engaged se-
curely.
Inspect that each ground lead is properly
secured.
EMU29174
Checking propeller
WARNING
EWM01881
You could be seriously injured if the en-
gine accidentally starts when you are near
the propeller. Before inspecting, remov-
ing, or installing the propeller, place the
shift control in neutral, turn the main
switch to “ ” (off) and remove the key,
and remove the clip from the engine shut-
off switch. Turn off the battery cut-off
switch if your boat has one.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
nut. Put a wood block between the anti-cavi-
tation plate and the propeller to prevent the
propeller from turning.
1. Oil dipstick
2. Lower level mark
3. Upper level mark
1
3
2
ZMU07057
U6AL32E0.book Page 76 Monday, April 9, 2012 11:55 AM
©2019 Yamaha Motor Corporation, U.S.A.

Table of Contents

Related product manuals