Yamaha NS-SW901 - User Manual

Questions and Answers

L
leechristinaAug 10, 2025
Why Yamaha NS-SW901 has no sound?
- A
  andersontracieAug 10, 2025
  If your Yamaha Subwoofer isn't producing any sound, here are a few things to check: * Ensure the volume isn't set to the minimum (0). If it is, increase the volume. * Verify that the speaker cables are securely connected. * The signals from the amplifier might be too low. Increase the volume of the amplifier or the component connected to it. * Confirm that the signal is being output from the subwoofer output terminal of the amplifier. Check the speaker mode setting on the amplifier.
G
Gilbert BrownAug 16, 2025
What to do if Yamaha NS-SW901 remote control does not work?
- B
  Bobby LyonsAug 16, 2025
  If your Yamaha Subwoofer's remote control isn't working, consider these potential causes and solutions: * Make sure you're within the operational range: a maximum of 6 meters and no more than 30 degrees off-axis from the front panel. * Reposition the unit if direct sunlight or light from an inverter-type fluorescent lamp is hitting the remote control sensor. * Replace all the batteries if they are weak. * Remove any obstacles that might be blocking the signal between the remote and the unit.
B
Brett WatkinsAug 21, 2025
How to fix Yamaha NS-SW901 if power is not supplied?
- R
  Roberta KellyAug 21, 2025
  If the power is not supplied to your Yamaha Subwoofer, even when the STANDBY/ON switch is pressed, ensure that the power plug is securely connected. If it is, check that the POWER switch is set to the ON position.
C
Cody LeonardAug 28, 2025
Why is Yamaha Subwoofer sound level too low?
- J
  Joel CantuAug 29, 2025
  If the sound level from your Yamaha Subwoofer is too low, consider the following: * Ensure that the speaker cables are correctly connected: L (left) to L, R (right) to R, “+” to “+” and “–” to “–.” * Adjust the phase setting to the other position. * If you are playing a source sound with few bass frequencies, play a source sound with bass frequencies, or set the H-CUT to a higher position. * Relocate the subwoofer or change its positioning angle, as standing waves may be influencing the sound.
V
Victoria GonzalesSep 3, 2025
Why does Yamaha NS-SW901 Subwoofer cause the household breaker to go off?
- C
  Caleb FullerSep 3, 2025
  If the household breaker goes off when using your Yamaha Subwoofer, it could be due to the unit consuming too much electricity when a high-level signal is input. Try turning down the volume on the amplifier connected to the unit, or cut off the power to other unused equipment.