Yamaha PSR-E463 - Clearing a User Song; Clearing a Specified Track from a User Song

Recording Your Performance
PSR-E463/PSR-EW410 Owner’s Manual
40
Quick Guide
 If you want to record only the Groove play-
back:
Press the [GROOVE CREATOR] button, and
then select the desired Groove. While holding
down the [REC] button, press the [A] button.
ACMP is automatically turned on.
3
Same as in steps 4 to 6 (page 38) in
“Quick Recording.”
Yo u can clear all tracks of a User Song.
1
Press the [SONG] button, then select the
User Song from 031–040 (User 1–10) to
be cleared.
2
Hold down the track [1/RIGHT] and [A]
buttons simultaneously for longer than a
second.
A confirmation message will appear on the dis-
play.
3
Press the [+/YES] button.
A confirmation message will appear on the dis-
play. To cancel this operation, press the [-] button.
4
Press the [+/YES] button to clear the
Song.
An in-progress message will appear briefly on the
display.
This lets you clear individual tracks from a User
Song.
1
Press the [SONG] button, and then
select the desired User Song from 031–
040 (User 1–10).
2
From [1/RIGHT]–[5] and [A], press the
Track button to be cleared for longer
than a second.
A confirmation message will appear on the dis-
play.
3
Press the [+/YES] button.
A confirmation message will appear on the dis-
play. To cancel this operation, press the [-] button.
4
Press the [+/YES] button to clear the
track.
An in-progress message will appear briefly on the
display.
• If the memory becomes full while recording, an alert mes-
sage will appear and recording will stop automatically. In
this case, delete unnecessary data by using the Clear
functions (below), and then execute the recording again.
Clearing a User Song
Press and
hold
NOTE
Hold simultaneously
for longer than a second.
ClrUser1
YES
Clearing a Specified Track from
a User Song
Hold for longer
than a second.
ClrTr1
YES