Yamaha RCX40 - Copying Point Data

4-83
4
Operation
11. “MANUAL” mode
2) Enter the point number to jump to, and press the key.
A jump is made so that the point data is displayed from the designated point
number.
Fig. 4-11-18 Point jump (2)
MANUAL>POINT 50%[MG][S0H0X]
————————————x———————y———————z———————r———
P100 = 0.00 0.00 0.00 0.00
P101 =
P102 = 10000 20000 10000 0
[POS] 50.00 100.00 5.00 10.00
EDIT TEACH JUMP VEL+ VEL-
COMNT: [ ]
11.2.5 Copying point data
Point data can be copied under another point number.
[Procedure]
1) Press the
F 6
(COPY) key in “MANUAL>POINT” mode.
The message “Copy(####-####,####)>“ appears on the guideline.
Fig. 4-11-19 Copying point data (1)
MANUAL>POINT 50% [MG][S0H0X]
————————————x———————y———————z———————r———
P30 = 100.00 250.00 15.00 30.00
P31 = 50.00 100.00 5.00 10.00
P32 = 122.62 -24.54 12.35 -23.11
[POS] 50.00 100.00 5.00 10.00
Copy(####-####,####)>
COMNT: [ ]
n
NOTE
Valid point numbers are from 0 to
4000.
n
NOTE
If a hand system flag is set in the point
data, the hand system flag will also be
copied.