9-31
9
Troubleshooting
1. Error Messages
14.22 : No start code (@)
Code : &H0E16
Meaning/Cause : Starting code "@" was not added at beginning of single line in
an on-line command.
Action : Add starting code "@" at the beginning of on-line command.
14.23 : Illegal command,Operating
Code : &H0E17
Meaning/Cause : During data editing, an on-line command was executed.
Action : After completing data edit, execute an on-line command.
14.24 : Illegal command,Running
Code : &H0E18
Meaning/Cause : During program run, a non-executable on-line command was
attempted.
Action : After stopping the program, execute the on-line system com-
mand which could not previously be executed.
14.25 : Illegal command in this mode
Code : &H0E19
Meaning/Cause : Cannot execute the specified online command in the current
mode.
Action : 1. Stop the online command.
2. Change the mode.
14.26 : Illegal command,SERVICE mode
Code : &H0E1A
Meaning/Cause : Unable to execute since operation is in SERVICE mode.
Action : 1. Cancel SERVICE mode.
2. Change the exclusive control settings so it can be used in
SERVICE mode.
14.31 : Illegal port type
Code : &H0E1F
Meaning/Cause : Communication port not specified.
Action : Contact our company with details on this problem.
[15] Memory card errors
15.1 : Invalid file attribute
Code : &H0F01
Meaning/Cause : a. Directory was accessed.
b. Read/write protected file was accessed.
Action : 1. Change to a file which can be accessed.
2. Change to a file allowing read/write.
To Next Page
