6-10
PERIODIC MAINTENANCE AND MINOR REPAIR
6
6. Remove the oil filter element and
O-rings.
7. Check the O-rings for damage
and replace them if necessary.
8. Clean the oil filter element with
solvent, and then install it.
NOTE:
Check the oil filter element for dam-
age and replace it if necessary.
9. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
1. Oil filter element
2. O-ring (×3)
12. Add the specified amount of the
recommended engine oil, and
then install and tighten the oil
filler bolt.
10. Install the oil filter element drain
bolt, and then tighten it to the
specified torque.
NOTE:
Make sure that the O-rings are prop-
erly seated.
11. Install the engine oil drain bolt,
and then tighten it to the speci-
fied torque.
Tightening torque:
Engine oil drain bolt:
20 Nm
(2.0 m0kgf, 14.5 ft0lbf)
Tightening torque:
Oil filter element drain bolt:
10 Nm
(1.0 m0kgf, 7.2 ft0lbf)
Tightening torque:
Oil filter element cover bolt:
10 Nm
(1.0 m0kgf, 7.2 ft0lbf)
Recommended oil:
See page 8-1.
Oil quantity:
Without oil filter element
removal:
1.1 L
(0.97 lmp qt, 1.16 US qt)
With oil filter element removal:
1.2 L
(1.06 lmp qt, 1.27 US qt)
Total amount (dry engine):
1.45 L
(1.28 lmp qt, 1.53 US qt)
5GF-9-14 (USA) 4/23/02 2:10 PM Page 49
To Next Page
Loading...
