3-7
Periodic service
3. Check the specific gravity of the electro-
lyte. Charge the battery if below specifica-
tion.
4. Check the battery leads and terminals for
corrosion. Clean using a file or sandpaper
if corroded.
5. Install the battery, and then install the
bands.
6. Connect the battery breather hose “1”, and
then fasten it using the clamp “2”.
Make sure that the battery breather hose is
connected properly and is not obstructed.
7. Connect the positive battery lead “3”, and
then connect the negative battery lead “4”.
Connect the positive battery lead to the bat-
tery terminal first.
Apply water resistant grease to the terminals to
minimize corrosion.
Steering master check
1. Turn the handlebar lock to lock and push it
back and forth.
2. Check for excessive play of the handlebar.
Check the bushings, bolts, and nuts if
there is excessive play. See “Steering pad
and handlebar cover” (8-1).
Steering cable check
1. Remove the rear and front seats.
2. Check the steering cable. Replace if
cracked or damaged.
3. Check the steering cable routing.
4. Lubricate the steering cable.
Specific gravity
1.265
To Next Page
Loading...
Need help?
General