8-28
8
11. Connect the coolant reservoir hose.
12. Pour the specified amount of fresh cool-
ant into the radiator, then install the radi-
ator cap.
13. Pour the specified amount of fresh cool-
ant into the reservoir, then install the res-
ervoir cap.
14. Remove the right panel and right rear
panel. (See page 8-11.)
15. Loosen the water pump air bleed bolt to
allow air to escape from the system.
16. When coolant begins to flow out, tighten
the bleed bolt.
17. Loosen the cylinder head air bleed bolt to
allow air to escape from the system.
Tightening torque:
Coolant drain bolt:
8 N·m (0.8 kgf·m, 5.9 lb·ft)
1. Water pump air bleed bolt
Tightening torque:
Water pump air bleed bolt:
8 N·m (0.8 kgf·m, 5.9 lb·ft)
UB3D7AE0.book Page 28 Tuesday, November 7, 2017 9:38 AM
To Next Page
Loading...
Need help?
General
