–10–
V Pass the rear brake switch lead between the frame
and rectifier/regulator. Do not pinch the rear brake
switch lead.
W Fasten the rear brake switch lead with a plastic
locking tie.
X To the speedometer light leads.
Y Place the rectifier/regulator coupler completely
inside the motorcycle body.
Z Pass the fuel tank breather hose and vacuum
chamber air vent hose through the holder.
AA Pass the speedometer cable through the holder.
AB Place the couplers behind the steeirng head.
P Route the sidestand switch and the lead wire under
the frame boss.
Q Fasten the sidestand switch lead with a metal
clamp.
R Connect the rear brake switch coupler in front of the
roll over valve stay.
S Install the plastic locking tie immediately below the
cable guide bracket.
T Pass the speedometer cable through the
speedometer cable holder.
U To the rectifier/regulator.
CABLE ROUTING
SPEC
To Next Page
Loading...
