● In order to avoid common issues:
（1） Do not separate or modify the device.
（2） Do not hit the display and keyboard (buttons) with a nail tip or a sharp tool.
（3） Hold the main body portion when you carry it.
（4） Do not drop the device or do not give excessive shock or vibration.
（5） Do not apply thinner, benzine, etc.
● In order to keep the device accurate:
（1） Do not operate near fire, steam, direct sunlight or wind from the air conditioner.
（2） Do not operate near devices like a microwave, which generate excessive shock, vibration or
electro-magnetic discharge.
（3） Operate under the designated environment (-10℃ ～ +40℃, 30％RH ～ 85％RH)
Measuring error may happen even under certain conditions if dew condensation generates:
1）Being operated or stored for a long time within a humid environment.
2）Sudden temperature changes even under low humidity (splashing cold water on the device)
3）Operating the device when exposed to direct cold air from a refrigerator or steam.
Storage and Disposal
●Storage
(1) Do not store the equipment in the place with high temperature/humidity or receiving direct
sunlight for a long period of time. It should also be noted that substantial changes in the
ambient temperature may cause condensation inside the equipment, resulting in a failure of the
operation
(2) This is an electronic precision equipment. Do not store it in the place where vibration and/or shock
can be expected.
●Disposal
(1) At time of disposal, it must be disposed of as an industrial waste (nonflammable waste). Make
sure to observe local regulations when disposing.
(2) When used batteries are disposed of, put scotch tapes on electrodes and dispose according to
the local regulations.
To Next Page
Loading...