Yanmar Lx490 - Replace the Turn Signal;Hazard Lights Bulb; Replace the Instrument Panel Light Bulb

15. SERVICE THE ELECTRICAL SYSTEM
15-7
Lx410/450/490 Operator's Manual
■ Replace the Turn Signal/Hazard Lights
Bulb
1. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking the
Tractor" on page 1-7.
2. Shut off the engine.
3. Chock all the tires safely and securely.
4. Allow the engine to cool down for several
minutes.
5. Remove the key.
6. Insert a flat screw driver into the slot at the side of
the lens and turn slowly to remove the lens.
• Perform the preceding procedure to the other
lens.
7. Push the turn signal/hazard lights bulb down and
rotate to remove.
(A) Lens
(B) Bulb
8. Insert the new turn signal/hazard lights bulb into
the socket and rotate to lock position.
9. Turn the starter key switch to ON position.
10.Turn on turn signal/hazard lights switch.
11.Make sure the turn signal/hazard lights are
functioning.
12.Install the lenses.
■ Replace the Instrument Panel Light
Bulb
1. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking the
Tractor" on page 1-7.
2. Shut off the engine.
3. Chock all the tires safely and securely.
4. Allow the engine to cool down for several
minutes.
5. Remove the key.
6. Remove the 4 bolts from the instrument panel
cover.
7. Remove the instrument panel cover.
(A) Bolts (8 pieces)
(B) Instrument panel cover
8. Remove the 4 bolts from the instrument panel
housing.
9. Carefully pull out the instrument panel rearward.
10.Remove the 6 screws from the instrument panel
housing back cover.
NOTE
● Service the turn signal/hazard lights, after
removing the front or rear lenses.
(A)
P15_6_Tail lights
(B)
450150107
0
0
0
0
5
5
5
1
1
2
2
3
450150108
(A)
(A) (A)
(B)
(A)