Yanmar Lx490 - Stopping Procedure

8-11
8. OPERATE THE TRACTOR
Lx410/450/490 Operator's Manual
■ Stopping Procedure
1. Make sure both brake pedals are securely
connected using the brake pedal connector lock
(F).
2. Push down Power Take Off (PTO) switch (B) to
OFF position.
3. Slow down the engine.
4. Depress the clutch pedal (E).
5. Depress both brake pedals (G) to stop the tractor.
6. Move the following levers to the N (neutral)
position:
• Primary gear lever (D)
• Range gear lever (C)
• Forward/N/reverse lever (A)
(A) Forward/N/reverse lever
(B) Power Take Off (PTO) switch
(C) Range gear lever
(D) Primary gear lever
(E) Clutch pedal
(F) Brake pedal connector lock
(G)Brake pedals
7. Push the 3-point hitch control lever forward to
lower any implements to the ground.
8. Engage the parking brake securely, for details,
see "6. Lock and Set the Parking Brake" on page
7-4.
9. Turn the starter key switch to OFF position.
■ Stop in an Emergency
1. Depress the clutch pedal.
2. Depress both brake pedals to stop the tractor.
3. Turn the starter key switch to OFF position.
4. Do not release the clutch pedal until the engine
and all moving parts have completely stopped.
5. If possible, lock the parking brake securely.
4. Stop the Tractor
Avoid injury!
● Make sure that the clutch pedal is depressed
fully.
! WARNING
P5-3 top view_2
(A)
(C)
(B)
(D)
(E)
40 IMG 4473b
(F)
(G)
● To prevent injury or property damage:
• always lock the parking brake when the
following levers are in N (neutral) position:
• primary gear lever
• range gear lever
• forward/N/reverse lever
• whether the engine is running or stopped
• the tractor wheels are free to move when the
levers are in the N (neutral) position
! WARNING