EasyManua.ls Logo

Yanmar Lx490 - Operate the Engine; Start the Engine

Yanmar Lx490
168 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-1
7. OPERATE THE ENGINE
Lx410/450/490 Operator's Manual
7. OPERATE THE ENGINE
● Always remain seated on the operator seat when:
• starting the engine
• operating the levers and controls
● Before starting the engine, always ensure:
• the primary gear lever is in the N (neutral)
position
• range gear lever is in the N (neutral) position
• forward/N/reverse lever is in the N (neutral)
position
• the parking brake lock is engaged
• Power Take Off (PTO) switch in the OFF position
● Always keep the retractable seatbelt fastened:
• whenever the Roll-Over Protective Structure
(ROPS) is in the unfolded "up" position and
locked securely
● Start the engine only with the starter key switch.
• avoid starting the engine by short circuiting
across the starter solenoid terminals with a
jumper wire
• by bypassing the safety start switch
● Before operation, ensure all the safety features
are functioning correctly. Make corrections as
necessary.
Always run or idle the engine in a
well ventilated area:
● To prevent serious illness or
death, caused by the colorless
and odorless carbon monoxide
emitted by the engine.
! WARNING
1. Start the Engine
● Always observe the following precautions
when starting the engine.
• before starting and during running the
engine:
• always drive the tractor outside or to a
well ventilated area
• to prevent serious illness or death caused
by the carbon monoxide contained in the
exhaust of the engine
● To prevent explosions, always use only
diesel fuel to start the engine.
● In cold weather, use the Intake Air Heater
System to help the engine start more
smoothly.
● To prevent injury or death from a runaway
tractor:
• avoid starting the engine by short circuiting
across the starter solenoid terminals with a
jumper wire
• the tractor starts in gear and begins to move
when the normal circuitry is bypassed
● When starting the engine:
• always remain seated on the operator seat
with the transmission in the N (neutral)
position
• do not under any circumstances attempt to
start the engine while the operator is still on
the ground
NOTE
● When the temperature is below 40°F (5°C), for
details, see "Start the Engine in Cold Weather"
on page 7-8.
! WARNING

Table of Contents