Yanmar Lx490 - Install an Implement to Power Take off (PTO) Driveline

9-4
9. POWER TAKE OFF (PTO) SYSTEM
Lx410/450/490 Operator's Manual
Use Power Take Off (PTO) with the operator out of
the operator seat.
1. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking
the Tractor" on page 1-7.
2. Shut off the engine.
3. Chock all the tires safely and securely.
(A) Parking brake lock lever
4. Move the primary gear lever to the N (neutral)
position and Power Take Off (PTO) switch to OFF
position.
5. Sit on the operator seat.
6. Start the engine.
7. Pull up Power Take Off (PTO) switch to ON
position.
(A) Clutch pedal
(B) Power Take Off (PTO) switch
3. Install an Implement to Power
Take Off (PTO) Driveline
Avoid injury!
● Before installation of an implement to Power
Take off (PTO) driveline,
• make sure that the tractor is stopped
• make sure that Power Take Off (PTO) switch
is in the OFF position
IMPORTANT
● Observe the driveline manufacturer installation
instructions for:
• driveline mounting angle
• length of the overlaps on the driveline shafts
● An incorrectly installed implement can promote
wear of the driveline and/or damage the tractor.
! WARNING
4 IMG_4473b
(A)
P5-3 top view_2
(A)
(B)