YASKAWA CIMR-G5M

1-24
1.4 . 7 E n code r Fee d b ack
If either the Flux Vector (A1-02 = 3) or Volts Per Hertz with Encoder (A1-02 = 1) control method is
desired, an encoder feedback board for the drive is required.
The drive can accept many types of encoder feedback. Table 1-4 shows which option board is
needed for each type of encoder.
Ta ble 1 -4. Enc ode r fe edb ack o pt ion b oar d ty pes .
The PG-X2 card also has a connector TA2 which provides processed PG signal output for
use by an external pulse monitor. This connection can be made according to Figure 1-5.
+12V (200mA) 1 White D D 6
0V 2 Black F F 1
+5V 3 No Connection No Connection No Connection No Connection
A+ 4 Red A A 3
A– 5 Green H H 8
B+ 6 Brown B B 2
B– 7 Yellow I I 7
SHIELD TA3 Shield E No Connection 10
PG-X2 EPC (1) DYNAPAR DYNAPAR LAKESHORE/
FUNCTION TERMINAL MODEL H-20 (2) HS-35 NORTHSTAR
TA1 755A (Pin #) SL-56
Table 1-5. Encoder (PG) Connection
( 1 )
For PG, EPC Model 755A, Orange and Blue wires are not used.
( 2 )
For PG, Dynapar H-20, pins C, G, and J are not used.
Op tion
Board
PG-X2
PG-W2*
PG-B2
PG-D2
PG-A2
Con trol
M e t h o d ( s )
ALL
ALL
ALL
All, Except
Flux Vector
All, Except
Flux Vector
Electrical Input
Scheme
Qu adr atu re,
Line Driver
Dual Input,
Quadrature, Line
Driver
Quadrature,
Single Ended
Line Driver
Single Ended
Required Signals From Encoder
A + , A -, B + , & B - ( Z + , Z - o p t i o n a l )
A+, A-, B+, B-, (Z+, Z- optional)
A, B, & Common
A+ & A-
A & Common
*Accepts inputs from two encoders. Primarily used with custom software.
The most common encoder used with the drive is the Quadrature, Line Driver style
encoder. When an encoder of this type is used, a PG-X2 option board must be
mounted onto the drive. The encoder then wires to the PG-X2 option board.
Table 1-5 and Figure 1-5 show connections for the PG-X2 and some typical encoders.