1 Overview of Setup
1-2
This chapter describes the flow of the setup procedure from installation until a JOG
operation. A digital operator and an engineering tool called SigmaWin+ that can be
used with a PC are available to set up a servo drive.
CAUTION
• An alarm or warning may be generated if communications are executed with the
host controller during operation using SigmaWin+ or the digital operator.
If an alarm or warning is generated, the process currently being executed may be aborted
and the system may stop.
• Be sure to read 4.2 Inspection and Checking before Trial Opera-
tion.
• The digital operator is available for both SERVOPACKs with ana-
log voltage reference and SERVOPACKs with pulse train refer-
ence.
Operation Reference (in this manual)
Install the servomotor and
SERVOPACK.
Chapter 2 Installation
↓
Perform the required wiring and
connections for a JOG operation.
Chapter 3 Wiring and Connection
↓
Perform a JOG operation for the
servomotor using the digital operator
or SigmaWin+.
Chapter 4 Trial Operation (Checking
Servomotor Operation)
Trial Operation Using the Digital
Operator
→4.3 JOG Operation Using a Digital
Operator
Trial Operation Using SigmaWin+.
→4.4 JOG Operation Using
SigmaWin+
To Next Page
Loading...
Need help?
General
