@ C01N signal is not output in feed hold• status.
D AST _ _ ..
STOP ' _-_
!
COIN [ t
I
MOTOR FEED HOLD
r/min 'l I
I I
I I
I I
_ t
•(TEMPORARY STOP) (REMAINING AMOUNT)
AsY _ L2
STOP [ [
1
COIN If t
I
0
t
(b) 0utput specifications in manual operation mode
In manual operation mode, COIN is output during Stop. When operation signal (MC_
MCCW)is turned off, COrNbecomes high.
MCCW(MCW_ I 1
COIN I I
MOTOR SPEED
r/rain
t/ , .
0 _. /..._._ ---t
SETTING WIDTH REACH
r
(8) Station No. Output (P0 to P4)
(a) Station No. reference method (parameter 15 set value = 0)
• Positioning station No. is indicated in BeD or binary code(5 bits).
(BCD/binary setting depends on parameter 14 b4.)
• By combining H and L levels of read-out input signal (PS0, PS1), the code contents
of PO to P4 changes. Refer to Par. 6.2.3 (6)(c).
(b) Commandtable method (parameter 15 set value = 4)
• By setting parameter 20 b5 = 1 and parameter 65 bO = 1, P-Oto P_ become zone signals.
-- 119--
To Next Page
Loading...
