(3) G Series Dimensionsinmm(inches)
Drawing 1 USAGED-02A_:;il, -03A!;-i1 (Taper Shaft)
L . LR j
. LT =1 LM _ LC t LE :: =55 : =
ENCODER_I , MOTOR LG _ (0216110 65(0226) 4
]
(01575)
oP,,CA1-, j \q to39,,M,,,o
J_._l,-_=J Ii 4-LZ .._
I. KB2 Detail of Shaft Extension
Notes :
I. Plug and clamp are not attached forreceptacleconnection.
2. Key and keyway comply with JIS B 1301-1976.
(Parallel key, keyway : common ctassJ
3 Motor should be mounted with connectors down•
4. f._in the models are as follows according to types of the encoder (P/R).
Standard :S (8_92 P/R)
Semi-standard ; W (1024 P/R)
Drawing 2 USAGED-05A!-;_I, -09A_:-_1(Taper Shaft), -13A_;.-_2(Straight Shaft.)
LR
. 6(1"32361LR
L 1810/(_) I_ 12[0472)
OP'FiCALENC MOTOR t.C, LE LC u__ (01968)
\ _ o _
• _] , m
._ SECT X.X
KB1 -- TAPER1/10
KB2
For -05AS1, -09AS1 For -13AS2
Detail of Shaft Extension
Notes :
1. Plug and clamp are not attached for receptacle connection.
2 Key and keyway comply with JIS B 1301-1976.
(Parallel key, keyway : common class)
3 Motor should be mounted with connectors down.
4. i."..in the models are as follows according to types of the encoder (P/R).
Standard : S (8192 P/R)
Semi-standard : W (1024 P/R)
Drawing 3 USAGED-20A_::i2 to -44A_::i2 (Straight Shaft)
L
. 2-M8 SCREWS (FOR EYEBOLT)
OPTICALENCOOER MOTOR LG LC LR
4-1_
I KRI
Ke2 Detail of Shaft Extension
Notes :
1. Plug and clamp are not attached for receptacle connection•
2. MOtOr should Oe mounted with connectors down.
3. E"..in the models are as follows according to types of the encoder (P/R).
Standard : S (8192 P/R)
Semi-standard : W (1024 P/R)
- 254 --
To Next Page
Loading...
