To Next PageTo Next Page
What does Braking Transistor Overload Fault mean on my YASKAWA iQpump1000?
If the YASKAWA Controller displays a Braking Transistor Overload Fault, it indicates that the braking transistor has reached its overload level.
What does Accumulated Level Fault mean on a YASKAWA iQpump1000?
An Accumulated Level Fault on the YASKAWA Controller means the total volume of water flow measured over time by the flow meter has exceeded the fault level setting.
What to do if YASKAWA DC Drives show operation errors?
If your YASKAWA DC Drives display operation errors, it's likely due to conflicting parameter settings or mismatches with the hardware setup. To resolve this, correct the settings that are causing the operation error. This should clear the error.
Why does my YASKAWA iQpump1000 Controller show a MEMOBUS/Modbus communication error?
A MEMOBUS/Modbus communication error on your YASKAWA Controller means that control data was not received for the CE detection time set to H5-09.
What does Control Board Connection Error mean on my YASKAWA iQpump1000?
If the YASKAWA Controller displays a Control Board Connection Error, this indicates that there is a connection error between the control board and the drive.
What does EEPROM Memory Data Error mean on my YASKAWA iQpump1000 Controller?
If the YASKAWA Controller displays an EEPROM Memory Data Error, this indicates there is an error in the data saved to EEPROM.
What causes a Drive Unit Signal Fault on a YASKAWA iQpump1000?
If the YASKAWA Controller displays a Drive Unit Signal Fault, it means the drive capacity cannot be detected correctly. This check happens when the drive is powered up.
What does SI-T3 Watchdog Timer Error mean on my YASKAWA Controller?
If the YASKAWA Controller displays SI-T3 Watchdog Timer Error, it means that the watchdog timed out.
What does Option Card External Fault mean on my YASKAWA iQpump1000?
If the YASKAWA Controller displays Option Card External Fault, it indicates that an external fault condition is present.
What does Pump Fault (input terminal S1) mean on my YASKAWA Controller?
If the YASKAWA Controller displays a Pump Fault (input terminal S1), it indicates there is an external fault at multi-function input terminal S1.
General| Brand | YASKAWA |
|---|---|
| Model | iQpump1000 |
| Category | Controller |
| Language | English |
