YASKAWA J1000 User Guide

Document Revision: v1.0.9
of
3 11
page
18805 Adams Ct., #110 ~ Morgan Hill, CA 95037, USA ~ +1-408.924.0808 ~ www.washlinksystems.com ~ support@washlinksystems.com
Document Title: Tech Guide ~ Yaskawa J1000/V1000/GA500 Basic User Guide
Output Frequency (Hz)
Output Current (Amps)
Output Voltage
Monitor Display (typically not used)
Verify Menu (typically not used)
Set Up Mode (typically not used)
Parameter Setting mode
Auto-Tuning
Hz drive set to run
Forward Selection/Reverse Selection (typically not used)
To Change Display Data View
The standard screen after a power cycle is the actual output in Hz (xx.xx)
To change data being displayed, press the or to the desired view.
J1000 & V1000
Display
J1000 & V1000
Display
ESCESC
AA
ESC
A
RESET
REV
DWEZ
RUNRUN
STOPSTOP
Display
GA500
ESC
A
RESET
REV
DWEZ
RUN
STOP
Display
GA500
J1000 & V1000
Display
ESC
A
RESET
REV
DWEZ
RUN
STOP
Display
GA500

YASKAWA J1000 Specifications

General

Series	J1000
Voltage Class	200V, 400V
Frequency	50/60 Hz
Enclosure Rating	IP20
Enclosure Type	Open type
Voltage	200-240V, 380-480V
Control Method	V/f control
Overload Capacity	150% for 60 seconds
Protection	Overcurrent, Overvoltage, Undervoltage, Overheat, Ground Fault, Short Circuit
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Humidity	5-95% (non-condensing)
Enclosure	IP20
Input Voltage	200-240V, 380-480V