6 Keypad Operation
YASKAWA TOEP C730600 97C LCD Keypad Installation Manual 47
■ JOG Operation
Push to illuminate . Push and hold (JOG)
to run the motor. Release to stop the motor.
■ Change Motor between Forward/Reverse Run
You can change the direction of motor rotation when you use the
keypad to operate the drive. Push to illuminate .
Push and hold (FWD/REV) to toggle the direction of motor
rotation between forward and reverse.
■ Show the Standard Monitor
Push to show the standard monitor (Ux-xx). Push
(HOME) to go back to the HOME screen.
Note:
When a fault, minor fault, or an error occurs, push to show the content of
the fault. Push again to show the standard monitor (Ux-xx).
■ Change the Frequency Reference Value
1. Push to access the screen to change the frequency.
2. Push or to select the digit, then push or
to change the value.
3. Push to keep the changes.
Note:
The HOME screen must show U1-01 [Frequency Reference] or you must set the
keypad as the Run command source (REMOTE) to use this function.
To Next Page
Loading...