YASKAWA MH SIGMA-5 Series

To Next Page

To Previous Page

1-6

162068-1CD

MH-SERIES

POSITIONER

1 Introduction

1.3 System Layout

1.3.1.3 Positioner Assembly (headstock and tailstock)

The positioner assembly integrates the headstock with a tailstock column

and the MotoMount compliant tool mounting system. This system is

designed to be floor-mounted or mounted to a machine base. Span

between the headstock and tailstock is determined by the application. The

standard configuration provides a 815-mm tooling sweep radius.

Fig. 1-5: Positioner Assembly (headstock and tailstock)

NOTE

If integrating the Yaskawa drive or headstock assembly with

other than Yaskawa tailstock or the MotoMount system voids

the warranty

TailStock

Assembly

HeadStock

Assembly

15/101

YASKAWA MH SIGMA-5 Series - Page 15