Table of Contents
viii
162068-1CD
162068-1CD
MH-SERIES
POSITIONER
4.3 Installing the MH-Series SIGMA-5 Positioner – Type II.....................................................4-8
4.3.1 Site Preparation....................................................................................................4-8
4.3.2 Unpacking.............................................................................................................4-8
4.3.3 Unbolting the Drive Assembly Floor Mounting – Type II.......................................4-9
4.3.4 Connecting the Cables .......................................................................................4-11
4.3.5 Home Position ....................................................................................................4-11
4.4 Tailstock Column Installation ...........................................................................................4-12
4.4.1 Type I Installation................................................................................................4-12
4.4.2 Type II Installation...............................................................................................4-13
4.4.3 Leveling the Tailstock .........................................................................................4-14
4.4.4 Tooling Fixture Installation (initial) ......................................................................4-17
4.4.5 Tooling Fixture Installation (regular) ...................................................................4-18
4.4.6 Final Alignment Check........................................................................................4-18
4.4.7 Tooling Fixture Removal.....................................................................................4-21
4.5 MotoMount Installation.....................................................................................................4-22
4.5.1 Preparation .........................................................................................................4-22
4.5.2 Unpack and Assemble........................................................................................4-22
4.5.3 Securing MotoMount Drive Components onto Faceplate...................................4-24
4.5.4 Retrofitting Tailstock Assembly...........................................................................4-24
4.6 MotoMount HD Adjustments............................................................................................4-25
4.6.1 Allowable Misalignment ......................................................................................4-25
4.6.2 Tooling Fixture Installation – MotoMount HD......................................................4-26
4.6.3 Tooling Fixture Removal.....................................................................................4-26
4.6.4 Variable Tooling Size Accommodations .............................................................4-27
4.7 Conducting a Safety/Operation Check.............................................................................4-27
5 Tooling Recommendations .............................................................................................................5-1
5.1 Headstock Only – Tooling Recommendations...................................................................5-1
5.1.1 Customer-supplied Tooling Fixture.......................................................................5-2
5.2 Headstock/Tailstock with MotoMount ................................................................................5-5
5.2.1 Customer-supplied Tooling Fixtures.....................................................................5-5
5.2.2 Multiple Tooling Fixtures.......................................................................................5-5
5.2.3 Specifications........................................................................................................5-5
To Next Page
Loading...