YASKAWA U1000 Series - Page 49

8 Standards Compliance
YASKAWA ELECTRIC TOBP C730600 95A U1000-Series Option PS-U10 Installation Manual 49
 EMC Guidelines Compliance
Yaskawa tested this option according to European standards EN 61800-3:2004/A1:2012.
The option complies with EMC guidelines. Yaskawa declared the CE mark based on the
harmonized standards.
Installation Method
Install the option with the following conditions to make sure that other devices and
machinery used with this option also comply with EMC guidelines.
1. Use dedicated shield cable for the option and external device, or put the wiring
through a metal conduit.
2. Keep wiring as short as possible and ground the largest possible surface area of the
shield to the metal panel according to Figure 40.
Figure 36
Figure 40 Ground Area
A – Braided shield cable C – Cable clamp (conductive)
B – Metal panel
CB
A
TOBP_C730600_95A_2_0_E.fm 49 ページ ２０２３年２月１３日 月曜日 午後１時８分