4. 3.2.1 Command Data Display
The display shows the block data under execu-
tion or just prior to execution in which compensa–
tion calculations have been completed. The con-
ditions of the data to be displayed is as follows.
(1) The data shows the contents of the active
register during an automatic operation or a
feed hold.
(2) While the control is stopped at a block end,
the contents of the buffer regiter are dis-
played.
If the buffer register blank (BUF
is not displayed) ,
the contents of the just
executed block are displayed.
r
—G CODES OF 01 TO 14 GROUPS
~NON-MODAL G CODE
,
3-AXIS MAX SPEED DESIGNATION
__J
-
SPEED OF 3-AXIS IN OPERATION
Fig. 4.16 Command Display
010000 ;
NO1OI
P2000QO11O M98
L1O ;
M30
)20000 ;
iol 10
!0200P3000QO120M98
La ;
“1”
M99
/
\
4. 3.2.2 Display of Subprogram Run Status
(SUB F’ROG. NESTING)
When the program being executed is in the sub-
program called by M98 (subprogram callcommand) ,
the following information is displayed :
CALL :
START :
LOOP :
NEST:
Example
The program number (O to NO) and
sequence number (N to NO) specified
with M98 (subprogram callcommand)
The program number (O to NO) and
number (N to NO) of the subprogram
called by M98
The remaining number of repetitions of
the subprogram by L ---- ‘(subprogram
repeat command, ❑ = L1, indicates the
number of repetitions)
The order in which subprogram multiple
call commands are called.
of Subprogram Run Status Display
Subprogram Remalmng Number of R’epeiitlons
Fig.4.17
030000 ;
No120
NO21OP4000QO130M98
L6 ;
‘,M99
>40000 ;
NO130
M99
CRT screen displays that the subprogram has executed the 3rd
level one time and entered into the execution of 3rd time of
the 3rd level
158
To Next Page
Loading...
