YASKAWA yasnac lx3 - Page 227

Parameter numbers are
following four groups.
APPENDIX 1
classified in the
LIST OF SETTING NUMBERS
Parameter numbers I
Group
=L4’v!=ELoN
Toggle switch
I
OFF
I
OFF ON
I
ON
on mschi ne
#6005 to #6029
Parameter (Setting by bit)
#6056 to #6134
Parameter (Setting by bite)
“:a=m
#6220 to #6344
Parameter (Setting by word)
1
I
1
—
#6600 to #6643
Parameter
(Setting by double word)
— —_——
#&301 ~ D7 D6 ~
Respective value of Leadscrew
— . ___L
#8000 to #8255
Error Compensation
(Setting by bite)
BUZON D7
INHEDTT
1:
Turns
o:
Turns
AFLT
1: Turns
o:
Turns
ABST
1: Turns
o: Turns
DRNT
1:
Turns
o:
Turns
BDTT
1:
Turns
o: Turns
DLKT
1: Turns
o: Turns
MLKT
1:
Turns
o:
Turns
SBKT
1:
Turns
o: Turns
D7 De
D5 ~ Da D3 D> , D,
1
D7
on Edit Lock function.
off Edit Lock function .
D6
on Auxiliary Function Lock .
off Auxiliary Function Lock.
D5
on Manual Absolute function.
off Manual Absolute function.
D4
on Dry Run function.
off Dry Run function.
D3
on Block Delete function .
off Block Delete function.
D2
on Display Lock function.
off Display Lock function.
D1
on Machine Lock function.
off Machine Lock function .
Do
on Single Block function .
off Single Block function.
1:
Turns on touch
~
ator’s panel) .
m O: Turns off touch
Notes:
1. These
switches.
settings are for setting internal toggle
buzzer (key
—.
switch on oper-
buzzer.
PSTMD1 : D6
1:
With PST1 mode is designation
o: No PST1 mode is designation
PSTMD2 : D5
1: With PST2 mode designation
o: No PST2 mode is designation
HINTPM : D4
1:
Enable handle interpolation function.
o: Disable handle interpolation function.
CMCHK: D3
1: Enable CMOS spare area check function.
o: Disable CMOS spare area check function.
SLT 3:
D2
1: Effective on the third Stored Stroke Limit.
o: Ineffective on the third Stored Stroke Limit.
The value of limit automatically changes by G38
or G39 command in part program.
SLT 2: D1
1:
Effective on the second Stored Stroke Limit,
o: Ineffective on the second Stored Stroke Limit.
The value of limit automatically changes by G36
or G37 command in part program.
INCHMM Do
1: Selects inch input increment.
o:
Selects metric input increment.
2.
When each switch is provided with machine
control station,
the logical sum of these set-
tings and toggle switch setting determines
function on /off state.
A–1