YASKAWA yasnac lx3 - Page 239

X!E ‘71D’D51D31D2D11D01
PERIAB
D7
1:
Incremental setting of offset value for Stored
Leadscrew Error Compensation.
o:
Absolute setting of offset value for Stored
Leadscrew Error Compensation.
PERST
D6
1:
Regards “%“ code as M30, if “%“ is commanded
before M02 or M30 in TAPE or MEM mode oper-
aiton.
o:
Ignores
IT%(1code if commanded before M02 or
M3 O in TAPE or MEM mode operation.
MCI-IMST D5
1:
Lights feedhold lamp and stores M, S, and T
commands when manual operation mode is
selected during automatic operation.
o:
Does not light feedhold lamp and M, S, and T
commands are forced to reset when manual
operation mode is selected during automatic
operation.
ONOCHG
D3
1:
Changes No. O by pressing O, program num-
ber, and ALT keys.
o:
Does not change No. O by pressing O, pro-
gram number, and ALT keys.
COVP
D2
1: Sets cut depth value override with cut depth
override input in Stroke Removal in Turning
(G71) and stock removal in facing (G72) .
0:
Sets cut depth value override with setting
#6004.
CLNO
D1
1:
outputs
Itoilby
inputting‘t:11and OUtplltS
“:“ by inputting
110,11in 1S0 code.
o:
Does not perform the conversion above.
HSRWD
Do
1:
Automatically starts at high speed in high-
speed rewinding.
o:
Does not start automatically at high speed in
high-speed rewinding.
Input for RS232C No.1
‘--— ~~D. ~D, ~ D, ~ D, I Do
~
=6026
SIFICI
D5
Determines whether the input control code for
RS232C interface is given or not.
Determines the
interface No. 1
1: Determines
o: D et ermines
input stop bit for RS232C
as two bits or one bit.
stop bit as two bits.
stop bit as one bit.
SIFIBID - SIFIBIA
D3 - Do
Sets input baud rate for RS232C interface No. 1
Baud Rate I SIFI BID
SIFI BIC SIFI BIB I SIF1 BIA
50
I o 0
010
Imloooll
1101 0 0 1 I o
150
‘- l“----
0 0
1 1
200
0
1
o~o
300
--}
0
1
0
‘ -}
1
-.
600 0 1 1
0
1200101
Ill
2400 \ 1 0 0
lo
4800 I 1 0 011
9600
I 1 0 110
Output for RS232 C No. 2
SIF2CI D5
Determines whether output control code for
RS232C No. 2 interface is sent or not.
1: Does not send control code.
o: Sends control code.
SIFISO D4
Determines output stop bit for RS232C interface
No. 2 as two bits or one bit.
1: Determines stop bit as two bits.
o:
Determines stop bit as one bit.
SIF2BID-SIF2B1A D3 - Do
Sets output baud rate for RS232C interface
No. 2.
1: Does not send control code.
o: Sends control code.
A–13