YASKAWA yasnac lx3 - Page 287

B: Basic
Table 6.7 List of G Codes (Cent’d)
O: Optional
G Code
I
Special
I
Special
GCcde I GCcde II
Group
~
Function
~
Section
G 50
G 92 G 92
*
*
G65
I
G65 ~ G65
09
*-- r:-:
10
G 70
I
G 70 G 72
G71
I
G71 G 73
G72 ~ G 72
G 74
G 73
I
G 73 G 75
*
G74 I G 74 G 76
-L- -- --- –-
G 75
~
G 75
G 77
G76 ~ G76 G 78
G90 ~ G 77 G 20
G92 ~ G 78 G21
‘- G-b -E79
G24 ~
01
~
G122 ~ G122 i G122
G123 ~
G123 ~ G123
02
04
03
11
G 111 ~
G 111 ~
G 111
a“=”il~”
*
+ --
Coordinate system setup
Maximum spindle revolution setup, work coordinate system setup
i Return of current display value to origin
~ User macro simple call
o
I
User macro modal call
o
~—-
User macro modal call cancel
+-—–
0
}----
~ Mirror image by programming ON o
Mirror image by programming OFF
o
-+–- --
.–-— —–..-~– -— --––—
Finishing cycle o
k.. ———. .———
Stock removal in turning o
—
Stock removal in facing o
———
Pattern repeating
Multiple repetitive cycles
o
L
———
Pack drilling in Z-axis
“o~--- +---
1
Automabc threadcuttlng cycle
Turning cycle A B
I Threading cycle B
~ Facing cycle B
B
[
~—–
Constant surface speed control o
~ Constant surface speed control cancel
~
~ had par minute (mmlmin)
Feed per revolution (mmlrev)
B
—
Absolute command
B
Incremental command
B
Tool registration start
o
Tool life control
—.
l~Jregis”atiOn ‘nd
o
Taper multiple bevelinglrounding
f“
o
Arc multiple bevelinglrounding
o
%+%- 13I.roovewdthcompensa~on
Cancel groove width compensation
10
0
Notes :
1.
2.
3.
G codes in groups from 01 through 11 are modal. When
4.
the control is energized with the power switch or reset,
5.
the G codes marked with
r
are automatically selected.
For G 00/G 01, G 98/G 99, and G 90/G 91, either one is
6.
selected as initial state by setting parameters.
G codes of* group are non-modal. They should not be
commanded together with the other G codes in one block. ~,
The modal G codes can be commanded mixedly in a
block.
G codes in section B are basic.
Standard G codes can be converted to special G codes
I by parameters. (basic feature)
Special G code II can be selected as optional func-
tion. When selected, the standard G codes and special
G code u cannot be used.
The initial states of G codes of 05, 07, 08 group when
the control is powered correspond to their respective
setting data.
A–61