Yealink SIP-T29G User Manual

User Guide for the SIP-T29G IP Phone
46
phone enters power-saving mode after it has been idle for a certain period of time.
The IP phone will exit power-saving mode if a phone event occurs:
 Press any key.
 Pick up the handset.
 Hang up the handset.
 There is an incoming call.
 A new prompt (e.g., missed call, new voice mail or forwarded call).
 The status of BLF key changes.
If the screen saver is enabled on your phone, power-saving mode will still occur.
You can configure the following power-saving settings:
 Office Hour
 Idle Timeout (minutes)
Note
Enabling the Power Saving via Web User Interface
The office hour and idle timeout (minutes) settings work only if the power saving feature is
enabled.
To enable the power saving feature via web user interface:
1. Click on Settings->Power Saving.
2. Select Enabled from the pull-down list of Power Saving.
3. Click Confirm to accept the change.
Power saving is configurable via web user interface only.

Yealink SIP-T29G Specifications

General

Speakerphone	Yes
Voice codecs	G.711, G.722, G.723, G.726, G.729ab, iLBC
Dual-Tone Multi-Frequency (DTMF) modes	In-band, Out-of band, SIP info
Lines quantity	10 lines
Phonebook capacity	1000 entries
Number of VoIP accounts	16
Display diagonal	4.3 \
Display resolution	480 x 272 pixels
USB 2.0 ports quantity	1
Ethernet LAN (RJ-45) ports	2
AC adapter input voltage	100 - 240 V
AC adapter output current	2 A
AC adapter output voltage	5 V
Power over Ethernet (PoE)	-
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Number of handles included	1 pc(s)
Harmonized System (HS) code	85171800
Volume control	Buttons

Weight and Dimensions

Depth	213 mm
Width	244 mm
Height	185 mm