EasyManuals Logo

Yealink SIP-T33G Administrator's Guide

Yealink SIP-T33G
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #130 background imageLoading...
Page #130 background image
Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
126
Permitted
Values
-1-Do not modify the handset configuration (Keep the original configuration of the handset).
0-Disabled, the backlight will be turned off after the handset is idle for about 10 seconds.
1-Enabled, the backlight will be turned off after the handset is idle for about 30 minutes.
Default
-1
Supported
Devices
W53H, W56H
Handset UI
OK > Settings > Display > Display Backlight > In Charger
Parameter
custom.handset.backlight_out_of_charger.enable <y0000000000xx>.cfg
Description
It enables or disables the handset backlight to be on for about 30 minutes when it is not charged.
Note: It will take effect on all handsets that are registered on the same phone. It works only if “stat-
ic.auto_provision.handset_configured.enable is set to 1 (Enabled).
Permitted
Values
-1-Do not modify the handset configuration (Keep the original configuration of the handset).
0-Disabled, the backlight will be turned off after the handset is idle for about 10 seconds.
1-Enabled, the backlight will be turned off after the handset is idle for about 30 minutes.
Default
-1
Supported
Devices
W53H, W56H
Handset UI
OK > Settings > Display > Display Backlight > Out Of Charger
Handset Keypad Light
You can enable the handset keypad light to light up the keypad when any key is pressed. This helps you dis-
tinguish keys from each other in a dark environment.
Topic
Handset Keypad Light Configuration
Handset Keypad Light Configuration
The following table lists the parameter you can use to configure the handset keypad light.
Parameter
custom.handset.keypad_light.enable <y0000000000xx>.cfg
Description
It enables or disables the handset to turn on the keypad light (digital key, # key, * key, TRAN key, and
Mute key) when any key is pressed.
Note: It will take effect on all handsets that are registered to the same phone. It works only if “stat-
ic.auto_provision.handset_configured.enable is set to 1 (Enabled).
Permitted
Values
-1-Do not modify the configuration.
0-Disabled
1-Enabled
Default
-1
Supported
Devices
W53H, W56H
Handset UI
OK > Settings > Display > Keypad LED

Table of Contents

Other manuals for Yealink SIP-T33G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T33G and is the answer not in the manual?

Yealink SIP-T33G Specifications

General IconGeneral
Wall MountableYes
Local Phonebook1000 entries
Opus CodecYes
Lines4
Supported CodecsOpus, G.722, G.711(A/μ), G.729AB, G.726, iLBC
Headset PortRJ9
NetworkDual-port Gigabit Ethernet
PoEYes (IEEE 802.3af)
Audio FeaturesHD voice
SIP Accounts4
Buttons4 context-sensitive soft keys
Headset SupportYes
Supported ProtocolsSIP
Operating Temperature0 ~ 40°C
Humidity10% to 90% (non-condensing)

Related product manuals