Yealink SIP-T33G

Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
407
(Enabled).
Permitted
Values
Integer greater than or equal to 0
Default
6
Parameter
forward.no_answer.on_code <y0000000000xx>.cfg
Description
It configures the no answer forward on code to activate the server-side no answer forward feature.
The phone will send the no answer forward on code and the pre-configured destination number (con-
figured by the parameter “forward.no_answer.target”) to the server when you activate the no answer
forward feature on a phone basis.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 0
(Phone) (except T30P/T30/T19(P) E2/CP920 phones).
Permitted
Values
String within 32 characters
Default
Blank
Web UI
Features > Forward&DND > Forward > No Answer Forward > On Code
Phone UI
Menu > Features > Call Forward > No Answer Forward > On Code
Parameter
forward.no_answer.off_code <y0000000000xx>.cfg
Description
It configures the no answer forward off code to deactivate the server-side no answer forward feature.
The phone will send the no answer forward off code to the server when you deactivate the no answer
forward feature on a phone basis.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 0
(Phone) (except T30P/T30/T19(P) E2/CP920 phones).
Permitted
Values
String within 32 characters
Default
Blank
Web UI
Features > Forward&DND > Forward > No Answer Forward > Off Code
Phone UI
Menu > Features > Call Forward > No Answer Forward > Off Code
Call Forward in Custom Mode Configuration
The following table lists the parameters you can use to configure call forward in custom mode.
Parameter
account.X.always_fwd.enable
[1]
<MAC>.cfg
Description
It triggers always forward feature to on or off.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 1
(Custom).
Permitted
Values
0-Off
1-On, incoming calls to the account X are forwarded to the destination number (configured by the para-
meter “account.X.always_fwd.target”) immediately.
Default
0
Supported
Devices
All phones except T30P, T30, T19(P) E2 and CP920