Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
89
[1]
If you change this parameter, the phone will reboot to make the change take effect.
User-Triggered Provisioning Settings Configuration
You can enable the users to trigger phones to perform provisioning by dialing an activation code. This method
works only if there is no registered account on the phone.
The following table lists the parameters you can use to configure settings for user-triggered provisioning.
Parameter
static.autoprovision.X.name
[1][2]
<y0000000000xx>.cfg
Description
It configures the code name to trigger auto provisioning.
Permitted
Values
String within 64 characters
Default
Blank
Parameter
static.autoprovision.X.code
[1][2]
<y0000000000xx>.cfg
Description
It configures the activation code to trigger auto provisioning.
Example:
static.autoprovision.1.code = 123
static.autoprovision.2.code = **
static.autoprovision.3.code = *123
Permitted
Values
Numbers, #/*, or a combination of numbers and */#
Default
Blank
Parameter
static.autoprovision.X.url
[1][2]
<y0000000000xx>.cfg
Description
It configures the access URL of the provisioning server for the phone to perform auto provisioning
which is triggered by an activation code.
Permitted
Values
URL within 511 characters
Default
Blank
Parameter
static.autoprovision.X.user
[1][2]
<y0000000000xx>.cfg
Description
It configures the user name for authentication during auto provisioning which is triggered by an activ-
ation code.
Permitted
Values
String within 64 characters
Default
Blank
Parameter
static.autoprovision.X.password
[1][2]
<y0000000000xx>.cfg
Description
It configures the password for authentication during auto provisioning which is triggered by an activ-
ation code.
Permitted
Values
String within 32 characters
Default
Blank
[1]
X is an activation code ID. X=1-50.
[2]
If you change this parameter, the phone will reboot to make the change take effect.
To Next Page
Loading...
Need help?
General
